TÀI LIỆU HƯỚNG DẪN - Ontrac MME MOE Intelligent Electric Actuator
Assembly and Installation Ontrac ®
1. Actuators can only be installed with solid mounted valves, in special case, it is necessary to reinforce the valves and pipelines.
2. If necessary, lifting equipment can be used to install, actuator weight is listed in below table. If there are additional components attached
such as gear boxes, linear drive unit, etc., please refer to relevant technical information.
3. If actuators are assemblied to the valves or heavier components, lifting actuator is prohibited, only lifting valves and gearing is allowed.
4. When actuators are assemblied to the valves, before full engagement with valve stem axis, do not bear the weight of actuator on the stem (axis).
5. After the installation of the actuators, please replace the upper most drain hole with a red one-way venting valve in attached zipper bag (see the picture).
6. After the installation of the actuators, if it can not be wiring right away, please do not remove wiring cover or sealing screw plug to avoid lower actuators protection level to below IP43.
Assembly and Installation Ontrac ®
1. Actuators can only be installed with solid mounted valves, in special case, it is necessary to reinforce the valves and pipelines.
2. If necessary, lifting equipment can be used to install, actuator weight is listed in below table. If there are additional components attached
such as gear boxes, linear drive unit, etc., please refer to relevant technical information.
3. If actuators are assemblied to the valves or heavier components, lifting actuator is prohibited, only lifting valves and gearing is allowed.
4. When actuators are assemblied to the valves, before full engagement with valve stem axis, do not bear the weight of actuator on the stem (axis).
5. After the installation of the actuators, please replace the upper most drain hole with a red one-way venting valve in attached zipper bag (see the picture).
6. After the installation of the actuators, if it can not be wiring right away, please do not remove wiring cover or sealing screw plug to avoid lower actuators protection level to below IP43.
Không có nhận xét nào: